Videos

Some milling we did on our new Haas VF2 SS
5/8" Garr Tools Alumaster 3fl EM
.06" Radial DOC
2.125" Axial DOC
15k RPM
100 IPM

GARR V5 Endmill

Using HSM to quickly and efficiently pocket out some carbon steel. Enjoy.

Material: 1018/1020 Carbon Steel, Cold Rolled, 9" Dia. Round
Operation: Profile Peel Milling (aka High Speed Milling, HSM)
Pre/Post-Processor: HSMWorks 2015
Machine/Control: 2013 Haas VF3

Tool: Garr Tool VRX 4-Flute, .500 Diameter, .020 Corner Radius
Coating: AlTiN/X.CEED (Titanium Aluminum Nitride)
Ramp Parameters: Vc = 400 SFM, Fz = .002 IPT, 4 Degree Helix
Profiling Parameters: Vc = 702 SFM, Fz = .0033 IPT, Ae=.100", Ap=.700", Constant Ae
Cooling: Cold Air

3/4" 3 flute Garr Alumastar endmill running in 6061 aluminum. Run at 196 IPM, 3/4" DOC, 50 % stepover, 4000 RPM. This application is running dry for viewing however coolant is necessary.

Garr Alumastar going at full power. Details in the video

Milling pockets, Garr 12mm Dia 3 flute solid carbide mill,
4500RPM 650mm/min, DOC 5mm/pass, coolant soluble oil 5 - 8%.

New Garr V5 cutting 4140 steel using OneCNC hsm machine strategy.
The V5 is a variable geometry 5 flute em with extra reach for aerospace materials. Details in the video.

Garr Alumastar 3 flute end mill cutting 6061 aluminum. 3/4" diameter at 196 IPM and 4000rpm. 3/4" doc and .300 stepover. Cat 40 taper machine, run with no coolant for demo only. You should run coolant with this tool. www.end-mills.com

GARR 16mm diameter VRX
RPM 3500
Feed 5000mm/min
AP 30mm

HEM Machining of 6061-T6 Ally Billet for Cal Poly San Luis Obispo's Formula SAE Electric Racecar.

3/8" Garr Tool Long Reach Alumistar 1300 SFM, .0075 ipt, .375 DOC, 33% Stepover
Haas VF3